Question

• How to add new moisture readings to an existing loss in Mitigate?
• How can I add new moisture readings on my visit?

Answer

Want a video walk through? Check out our video guide for simple steps on adding moisture readings to Mitigate! 

1. In the Snapshot view/tab, scroll down to the Moisture Content card
2. Tap the More icon on the Moisture Content card
3. Locate the Room that you want to add new moisture readings to by clicking on the Drying Chamber dropdown at the top of the Moisture Readings overview page.
   
4. Once you are inside of a Room, you can either add a new location (point) to track moisture readings (eg Dry Wall, Floor/Carpet, Floor Plywood, etc) or you can add new readings to an existing location (for your subsequent visit).
5. On this page you can add a new trip to begin entering your moisture readings. 
   • You can also add a new location to track moisture readings if there is an area of interest.
6. NOTE: alternatively you can flip to the grid view to see the timeline of visits + readings for each location by clicking on the grid icon in the top right. This page also has the options to either add a new trip or add a new location for readings.
   

Questions? Contact Us!